GRAPHITE 58G529 Mode D'emploi page 14

TRANSLATION OF THE ORIGINAL INSTRUCTIONS
NOTE: BEFORE THE POWER TOOL IS USED FOR THE FIRST TIME, READ THIS INSTRUCTION MANUAL AND
KEEP IT FOR FUTURE REFERENCE.
PRECAUTIONS FOR USING ROTARY HAMMER
•
Wear ear protectors. Exposure to noise can cause hearing loss.
•
Use auxiliary handle(s), if supplied with the tool. Loos of control can cause personal injury.
•
Hold power tool by insulated gripping surfaces, when performing an operation where the cutting
accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and could give the operator an electric shock.
•
Use proper equipment to locate hidden power lines. Contact with live wires may cause fire or electric
shock. Damage of gas installation pipe may cause explosion. Ingress to water line may cause electric
shock and cause major property damage.
•
Each time before connecting the power tool check the power cord, in case of damage hand over to
authorized workshop for replacement.
•
When operating the power tool hold it in both hands while keeping stable body position. Keep the
handles clean. Power tool is safer when held with two hands.
•
When operating the power tool held high, stand firmly on the ground and ensure there are no
bystanders below.
•
Avoid touching rotating parts. Touching of rotating power tool parts, equipment in particular, may
cause body injury.
•
Wait until power tools comes to a complete stop before putting it away. Working tool may jam and
cause loss of control over the power tool.
•
Do not direct operating power tool at other persons or at yourself.
•
Use anti dust mask during operation to protect respiratory system.
CAUTION: This device is designed to operate indoors.
The design is assumed to be safe, protection measures and additional safety systems are used, ne-
vertheless there is always a small risk of injuries at work.
Explanation of used symbols
1 2
1. Read instruction manual, observe warnings and safety conditions therein.
2. Device with class II insulation.
3. Use personal protection measures (protective goggles, earmuff protectors, anti-dust mask)
4. Disconnect the power cord before starting maintenance or operation.
5. Protect against rain.
6. Keep the tool away from children.
CONSTRUCTION AND USE
Rotary hammer is a hand-operated power tool with insulation class II. The tool is driven by single-phase
commutator motor with rotational speed reduced with gear transmission. Rotary hammer can be used for
drilling holes in working modes: with impact, rotation only, chasing or surface processing of materials such
as concrete, stone, brick etc. Range of use covers repair and building works, woodworking and any work
from the scope of individual, amateur activities (tinkering).
ROTARY HAMMER
58G529
DETAILED SAFETY REGULATIONS
3 4 5
14
6