Description; Technical Specifications; Plug In The Charger; Install The Batteries - Adeunis RF Vokkero Evolution 3 Notice D'emploi

1.

Description

The ARF7578 "3 slot battery charger" is used to charge and recharge the Vokkero communication system batteries.
Each charger can simultaneously charge up to 3 batteries, which come up in two different capacity : 1130 mAh &
2260 mAh.
Note 1 : the connection of the ARF7578 "3 slot battery charger" on an IT network is only possible in Norway.
Note 2 : Depending of the destination of use, the ARF7578 "3 slot battery charger" is delivered with an European
or North-American power supply cable. For any other country (European or other) requiring a specific power supply
cable, please use one equipped with a plug conform to the local standards.
2.

Technical Specifications

AC/DC converter unit electrical supply
Operating temperature
Charge duration
Dimensions
Battery lifetime
3.

Plug in the charger

• Connect the power supply unit to the socket located on the left side of the charger.
• Connect the power supply unit to the main.
• When plugged in, the 3 LEDs (at the front of the charger) will first turn orange, then they will turn off one after the
other, and finally simultaneously flash green.
• The charger is ready to be used.
4.

Install the batteries

• Place the batteries on the charger (golden contact facing down).
• When the battery has been detected, the corresponding LED turns red.
• If the corresponding LED doesn't light, check that the battery has been correctly positioned.
100- 240 V ~ 1.5 A- 50 to 60 Hz
5°C to 45 °C (41°F to 113°F)
• 5 hours (batt. 2260 mAh)
• 2.5 hours (batt. 1130 mAh)
L: 143mm * H: 39 mm * W: 75 mm
> 500 cycles
10