Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SAFETY BLOCK
This function can be selected at any time
while using the oven.
To activate the function, press
seconds until you hear a beep and the
symbol appears on the display. The oven is
locked.
If the oven is off and you activate the safety
block function, the oven will not work even if
a cooking function is selected.
If this function is activated while you are
cooking, it will only lock the display and
keys.
Teka Hydroclean
This function makes it easy to remove grease
and other food debris that may have stuck to
the sides of the oven.
For easier cleaning, do not allow dirt to
accumulate. Clean the oven frequently.
PROGRAMING THE TEKA HYDROCLEAN
FUNCTION
Do not pour water into a hot oven as this
can damage the enamel of the oven.
Always run the cycle on a cold oven. The
result could be affected and the varnish
damaged if it is run when the oven is too hot.
First remove the trays and all accessories
from the oven interior, including the tray
supports and telescopic guide rails.
for a few
®
function
®
To deactivate the safety block function,
press
for a few seconds until you hear a
beep.
SHOWROOM MODE
The showroom mode is used in showrooms,
to show the clients how the oven works as
activation of the heating loads.
To activate the showroom mode press
and
.
To deactivate the function press
again.
To do this, follow the instructions in the
installation
and
accompanying the oven.
1. With the oven cold, spread a cloth out on
the bottom of the oven.
2. Gently pour 200 ml of water into the
bottom of the oven cavity.
For best results, add a teaspoon of mild
washing up detergent to the glass of
water before pouring onto the cloth
EN
and
maintenance
guide
11
Publicité
Table des Matières
