IFM VSE951 Notice D'utilisation page 22

VSE951
Attribut Nom
3 Number of
instances
Attributs de l'instance
Attribut Nom
1 Interface speed
2 Interface flags
3 Physical address
5 Media
counters
6 Interface
control
7 Interface Type
8 Interface State
22
Accès Type de données
Get UINT
Accès Type de données
Get UDINT
Get DWORD
Get ARRAY of 6 USINTs
Get Structure of 12
UINTs
Get, Set Structure of
WORD
Get USINT
Get USINT
Electronique de diagnostic
Valeur
2
Valeur / description
Interface Speed currently in use. Speed in
bps
(e.g. 10,100)
Bit 0 - Link Status
Bit 1 - Half/Full Duplex Status (0= Half
Duplex, 1= Full Duplex)
Bit 2...4 - Auto negotiation Status
(0=Auto negotiation in progress;
1=Auto negotiation and Speed detection
failed;
2=Auto negotiation failed but detected
Speed;
3 = Successfully negotiated; 4 = Auto ne-
gotiation not attempted)
Bit 5 - Not supported
Bit 6 - Not supported
Bit 7...31 - Reserved
Interface specific counters
Details are defined in
„THE CIP NETWORKS LIBRARY Volume
2
EtherNet/IP Adaptation of CIP"
Media specific counters
„THE CIP NETWORKS LIBRARY Volume
2
EtherNet/IP Adaptation of CIP"
Interface Control Bits
Bit 0 - Auto negotiation
(0 = active; 1 = inactive)
Bit 1 - Half/Full Duplex
(0 = half duplex;
1 = full duplex)
Bit 2...15 - reserved
Data rate
(10 = 10Mbps;
100 = 100Mps)
Type of interface:
0 = Unknown interface type
1 = The interface is internal to the device
2 = Twisted pair
3 = Optical fiber
4..255 = Reserved
Current operational state of the interface:
0 = Unknown interface state
1 = The interface is enabled and is ready
to send and receive data
2 = The interface is disabled
3 = The interface is testing
4...255 = Reserved