Castolin MIG 170 multi Manuel D'utilisation page 17

MIG 170 multi
& rear louver vents. Dirt, dust or any foreign material that can be drawn through
vents into welder must be kept to a minimum. Failure to observe these
precautions can result in excessive operating temperatures which can lead to
plant failure.
Grinding
Do not direct grinding particles towards the welder. An abundance of conductive
material can cause plant failure.
Stacking
This machine cannot be stacked.
Transport – Unloading
Never underestimate the weight of equipment, never move or leave suspended in
the air above people.
WARNING!
Falling Equipment can cause injury. Never lift welder with gas bottle attached.
Never lift above personnel.
Tilting
Machine must be placed on a secure level surface
Environmental Rating
The welding power source carries the IP21S rating. It may be used in normal
industrial and commercial environments. Avoid using in areas where water / rain
is around.
Read and follow the 'Electric Shock Warnings' in the safety section if welding
must be performed under electrically hazardous conditions such as welding in wet
areas or water on the work piece.
17