YATO YG-03065 Instructions page 9

GB
protected from direct sunlight.
Do not place and use the product in an environment with an increased risk of explosion,
containing fl ammable liquids, gases or vapours.
The product is intended only for indoor use. Do not expose the product to atmospheric pre-
cipitations or moisture. Water and moisture that penetrates the inside of the product increas-
es the risk of electric shock. Do not immerse the product in water or any other liquid.
Recommendations for connecting the product to power supply
Before connecting the product to power supply, make sure that the voltage, frequency, and
capacity of mains supply correspond to values shown on the product rating plate. Plug must
fi t into the socket. Any modifi cations of plug are forbidden.
Product must be connected directly to a single power outlet. It is forbidden to use extension
cords, socket-outlet adapters and double power outlets. Power supply circuit must be fi tted
with a protective conductor and at least 16 A protection circuit.
Avoid any contact of power cord with sharp edges and hot objects and surfaces. When op-
erating the product, the power cord must always be fully unwound and its position may not
interfere with the operation of product. Laying of power cable cannot result in tripping hazard.
Power outlet should be located in such a place to allow always the possibility of quick discon-
necting the plug of power cord supplying the product. When disconnecting the plug of power
cord always pull the plug housing, never the cable.
If the power cord or plug is damaged, disconnect it immediately from the mains and contact
an authorized manufacturer's service centre for replacement. Do not use the product with a
damaged power cord or plug. Power cord or plug cannot be repaired, in case of any damage
to these components, replace them with new ones without defects.
If the product was delivered without a power cord plug, it means that the connection to
mains must be done by a qualifi ed electrician.
Recommendations for handling the product
Before the assemble, disassemble or adjustment of product accessories, disconnect the
power plug from the mains outlet.
Before the start of the product, make sure that the selected accessory has been correctly
mounted.
Do not overload the product. Housing temperature cannot exceed 60 C. Product overload-
O
ing will cause its quicker wear, and may also cause damage and increase the risk of electric
shock.
While working, the product should be kept under supervision at all times.
The product features safeguards to protect the user against hazards resulting from improper
installation. In case of improper installation of the bowl and improper use of covers, it will not
be possible to start the product.
This product is not designed for use by children. Keep the product and its cable out of reach
of children. It is important to take care that children do not treat the product as a toy.
Unattended children should not perform cleaning and maintenance of the product.
This product is not designed for use by persons with reduced physical or mental capabilities
and person with no experience or knowledge of the equipment. Children should not play
O R I G I N A L I N S T R U C T I O N S
9