Glacier bay 703474 Guide D'installation Et D'entretien page 6

Installation (continued)
5
Installing the stopper and ball
rod
NOTE: In shallow cabinet installations, the ball rod (P) may
need to be shortened. Use a hack saw to cut the end of the
rod, away from the ball, to the desired length.
□
Insert the stopper (J) into the drain hole in the
sink.
□
Remove the lift rod strap (S) and spring clip (Q)
from the ball rod (P).
□
Remove the ball nut (O). Insert the ball rod (P)
into the drain body (N) and through the hole of
the stopper (J). See Insert 1.
□
For easier removal and cleaning, rotate the
stopper (J) 90 degrees so that the ball rod (P)
does not go through the hole in the stopper (J).
See Insert 2.
□
Secure the ball nut (O) against the hole in the
drain body (N) and tighten the ball nut (O) onto
the threaded end. Do not overtighten.
Insert 2
N
J
1
N
Insert 1
S
P
O
Q
6
Installing the lift rod
□
Insert the lift rod (T) through the faucet (A) and
down into the lift rod strap (S). Tighten the
thumb screw (R).
6
T
A
T
R
S
R