Fuses Replacement; Disposal Of Waste Materials - Videotec WAS Serie Manuel D'instructions

7 Maintaining

7.1 Fuses replacement

7.1.1 Replacing the fuse of the pump
board
The used fuse is described below.
• T 4A H 250V: BUSSMANN S505-4-R or
OMEGA GT520240
As an alternative, use an approved fuse featuring the
same characteristics.
For further information refer to the relative
chapter (6.5.1 Installing the fuse, page 5).
7.1.2 Replacing the fuse on the pump
inlet
Operation valid for pump with 5m (16ft) or
11m (36ft) delivery.
The used fuses are described below.
Pump with 5m (16ft) delivery:
• T 2A L 250V: BUSSMANN S506-2-R or
OMEGA ST522220
Pump with 11m (36ft) delivery:
• T 4A L 250V: BUSSMANN S506-4-R or
OMEGA ST522240
As an alternative, use an approved fuse featuring the
same characteristics.
Once the box is open identify the fuse position.
Fig. 12
Check the causes that caused the fuse breakage.
In the event the problem occurs again, contact the
technical assistance service.
MNVKWAS_1511_EN
8 Disposal of waste
materials
This symbol mark and recycle system
are applied only to EU countries and not
applied to the countries in the other area of
the world.
Your product is designed and manufactured with
high quality materials and components which can be
recycled and reused.
This symbol means that electrical and electronic
equipment, at their end-of-life, should be disposed of
separately from your household waste.
Please dispose of this equipment at your local
Community waste collection or Recycling centre.
In the European Union there are separate collection
systems for used electrical and electronic products.
7