Board Description - Videotec WAS Serie Manuel D'instructions

6.2 Choosing the power supply
Depending on the version, the device can be
provided with different power supply voltages. Their
value is shown on the product identification label.
When commencing installation make sure
that the specifications for the power supply
for the installation correspond with those
required by the device.
Electrical connections must be performed
with the power supply disconnected and
the circuit-breaker open.
Make sure that the power source and
connecting cables are suitable for the
power consumption of the system.
Use a power cable that is suitable for
outdoor use (ES H05RH-F).
6.3 Open the box
Operation valid for pump with 5m (16ft) or
11m (36ft) delivery.
Open the cover of the water-proof box and connect
as described below.
Fig. 4
4

6.4 Board description

Operation valid for pump with 5m (16ft) or
11m (36ft) delivery.
BOARD DESCRIPTION
Connector Function
J5 Board power supply
FUS1 Power supply selection fuse (230Vac)
FUS2 Power supply selection fuse (120Vac)
FUS3 Power supply selection fuse (24Vac)
Tab. 1
Fig. 5
FUS1
FUS2
FUS3
J5
MNVKWAS_1511_EN