Pump Installation - Videotec WAS Serie Manuel D'instructions

6.7 Pump installation

Be very careful not to start the pump when
the tank is empty.
If present, the float switch allows to
automatically stop the pump.
6.7.1 Pump with 5m (16ft) or 11m (36ft)
delivery
Fill the tank with water and insert it in the metal cage.
Insert the pump in the tank and tighten the cap.
The system is ready to be powered.
6.7.2 Pump with 30m (98ft) delivery
Avoid contact with the pump motor.
Surfaces are hot and may cause personal
injury if touched.
Adjust the position of the level controller and the
weight.
Fig. 9
6
220mm
120mm
Fill the tank with water and insert it in the metal
cage, taking care to insert the male/female hydraulic
coupling (01) correctly. Put the float inside the tank
and screw the plug on. Check the delivery hose
coupling for the pump (02) to make sure a small
quantity of water comes out.
01
Fig. 10
Unscrew the nut (01). Slide it along the delivery pipe
(02). Insert the end of the pipe into the ogive (03).
Lock the nut to the coupling.
03
Fig. 11
The system is ready to be powered.
02
02
01
MNVKWAS_1511_EN