Battery Removal - Emist EPIX360 Mode D'emploi

MAINTENANCE & CLEANING

BATTERY REMOVAL

• Make sure the system is off.
• Remove the battery from the sprayer by grasping the battery pack
firmly, depress the battery pack button down and slide out from the
bottom of the unit.
• Place battery into charger to fully charge for next usage. Each battery
takes approximately 45 minutes to fully charge.
• Store batteries and chargers in a cool, dry place.
STORAGE
Empty fluid or run until empty
• Insert at least 4 oz of water into the liquid tank.
• Run the sprayer for at least 1-2 minutes to flush active chemicals from
the system.
• Remove batteries and re-charge by placing on the charger.
• Wipe down exterior with water or alcohol to remove dirt and soil.
• Use the battery power indicator to determine the `battery's state of
charge (3 bars = full charge).
• Remove the tank and battery from the system when not in use.
This keeps the unit from leaking or getting any fluid into the battery
compartment or the contacts.
CAUTION:
DO NOT STORE THE SPRAYER IN AN AREA
THAT MAY FREEZE (TO AVOID DAMAGE FROM LIQUID
REMAINING IN THE SYSTEM AND LINES). THIS WILL
VOID THE WARRANTY. DO NOT STORE THE UNIT IN
EXTREME HEAT, AS IT DOES HAVE CIRCUIT BOARDS
AND ELECTRICAL COMPONENTS. THIS WILL VOID THE
WARRANTY.
TO PREVENT CROSS CONTAMINATION OF CHEMICALS,
YOU MUST PERFORM A FLUSH ANY TIME YOU CHANGE
THE TYPE OF CHEMICALS BEING USED.
©2021 EMist® is a registered trademark of SanoTech 360, LLC. All rights reserved.
EMI-018-21 Multilingual Manuals - 040521
EN