Emist EPIX360 Mode D'emploi page 11

ASSEMBLY & OPERATING INSTRUCTIONS
Caution: If a tank liner is not used, then the liquid will leak from the small
holes in the bottom of the tank.
These holes allow for air to escape through the tank itself to collapse the
liner. Collapsing the liner, is what makes the system capble of using all liquid
solutions and provide all directional spraying.
Warning: Do not plug the hole in the bottom of the tank to keep from using
the tank liner. This is considered a modification to the product and will void the
warranty if done. There is high potential for burning up the pump if this is done.
y Once this is completed, pour the diluted or ready to use solution into the tank.
Step 5: Installing the Tank Cap and Cover:
y To install the tank cap, gently turn clockwise against the threads until the cap
no longer turns.
y Each tank cap has a stopper along the tank that prevents overturning.
y To install the tank cap cover, simply line the opening of the cover with the nose
of the tank cap.
Step 6: Installing the 8oz Liquid Tank:
y To install the 8oz tank onto the sprayer, align the tank nozzle to the port on the
body of the sprayer and gently press in until you hear a click. This is the tank
lock locking into place along with the tank back clip. This is what holds the
overall tank in place.
Step 7: Depress the Trigger Button to Begin Spraying:
y Once the system has been filled with liquid solution, you can begin spraying.
y Depress the trigger button located on the front of the sprayer handle, hold it
down for the entire spray time required for surface treatment.
y The red indicator light at the back of the system indicates power on, and the
high voltage power supply is charging the liquid droplets and recognizes power
to the system.
Tip: When first starting to spray, the system needs to be primed with liquid, hold
down the trigger button for 10 to 15 seconds or until the sprayer produces the
mist. This needs to be done every time a tank is refilled, or the liner has been
replaced.
©2021 EMist® is a registered trademark of SanoTech 360, LLC. All rights reserved.
EMI-018-21 Multilingual Manuals - 040521
EN