Cover Open Notification Display; Reset The User-Selected Filter Replacement Cycle - Coway Airmega 250 Manuel De L'utilisateur

Cover Open Notification Display

When opening the cover while using the product
When the front cover is detected open for more than 2 seconds, all indicators will turn off and the
product stops all operation. When the front cover is detected closed for more than 1 second, the
product returns to the previous operation mode.

Reset The User-Selected Filter Replacement Cycle

This instruction is a guide for the next filter replacement maintenance. The filter replacement and cleaning
cycle selected by the user when the user replaces or cleans a filter by themselves before the filter replacement
notification is displayed.
Flash Flash
Indicators are Indicators are
turned off turned off
1 Press the [Filter reset] button and [Light]
button at the same time for more than 2
seconds.
2 The pre-filter indicator will start blinking. Then
press the [Filter reset] button to select the filter
that needs to be replaced or cleaned. Also, if
you press the [Filter reset] button for more than
2 seconds, the selected filter option will reset.
· A filter is selected in the following order. 
Pre-filter → max2 filter → pre-filter & max2 filter →
pre-filter
· I f you do not reset the filter and press the [Light]
button and the [Filter reset] button again at the same
time for about more than 2 seconds, or if you do not
press the [Mode] button or the [Filter reset] button
for 10 seconds, the filter is automatically canceled.
NOTE
If you replaced or managed the filter before a filter
•
replacement alarm is displayed, reset the filter
replacement cycle using the user-selected filter
replacement cycle reset function.
A djusting the sensitivity of air quality sensor and
•
resetting the user-selected filter replacement cycle
have the same entering and canceling method.
17