Checking The Air Quality; Adjusting The Sensor Sensitivity - Coway Airmega 250 Manuel De L'utilisateur

04 OPERATION

Checking the Air Quality

You can easily check the current air quality around the product using the air quality indicator on the front of the
product.
NOTE
For 250S/250 users, you can also check the current air quality in the smart phone application.
Air quality indicator

Adjusting the Sensor Sensitivity

You can adjust the pollution sensor's sensitivity.
16
Air quality indicator
This indicator displays the indoor air quality in
LED colors.
Good (blue) → Moderate (green) → Unhealthy
(yellow) → Very unhealthy (Red)
1 While the product is operating, press the
[Mode] button and the [Speed] button at
the same time for more than 2 seconds.
The speed indicator blinks to display the
current sensor sensitivity level.
· Initial sensor sensitivity is at the normal level.
2 Press the [Mode] button to adjust it to the
desired sensitivity.The mode indicator
blinks as shown below once sensor
sensitivity has been selected.
1
Sensitivity Sensitive
3 Press the [Mode] button and the [Speed]
button at the same time for more than
about 2 seconds, the selected sensitivity
will be inputted and the product will start
operating normally.
 I f the [Speed] button are not pressed for 10
·
seconds,the selected sensitivity of the sensor is
automatically entered.
2 3
Less
Normal
sensitive