Power Button; Light Button - Coway Airmega 250 Manuel De L'utilisateur

button/indicator

1 Power button

Use the button to turn the product
on and off.
-  W hen the product operates for
the first time, it is operated in the
smart mode. If you turn off the
product during operation and
turn it on again, it is operated
in the mode active before the
product was turned off.
3 Speed button / indicator
Press the speed button to select
the level 1 → level 2 → level 3.
The indicator is turned on when
the speed level 1/level 2/level 3 is
selected.
F ilter reset button / indicator 
5
When the filter replacement indicator is turned on, press the corresponding button for more
than 3 seconds after cleaning and replacing the filter.
The indicator stays on during the filter cleaning/replacement cycle. When the cleaning cycle or
life becomes less than 2%, the corresponding indicator will emit an orange color light.
-  I f both indicators(PRE and MAX2) turn on at the same time, the filters can be reset at once.
- If the filter replacement indicator is not turned on, the related button functions do not operate.
-  I f you have replaced or repaired the filter before the filter replacement indicator was turned
on, refer to page 18.
-  T he cleaning and replacement cycle of the pre-filter and combined filter is recommended and
may vary depending on the use environment.
6 W i-Fi button / indicator
(Only 250S)
Touch the Wi-Fi button to connect
to a Wi-Fi network.
When connected to Wi-Fi, the
status indicator's light will turn on.
7 L ight sensor
This sensor detects light around
the product.
2 Mode button / indicator
Press the mode button to select
the smart mode → rapid mode →
sleep mode.

4 Light button

Use this button to turn on and
off the indicator and air quality
indicator. If you press the [Light]
button while all indicators and the
air quality indicator are turned
on, you can turn on and off the
indicators in the following order:
Air quality indicator off → all
indicators off → all indicators on.
6  T imer button / indicator
(Only 250)
Press the timer button to set the
timer.
8 A ir quality indicator
This indicator displays the indoor 
air quality in LED colors. 
Good (blue) → Moderate (green) →
Unhealthy (yellow) → Very unhealthy
(Red)
11