Jung 500.600.110 Instructions D'utilisation page 16

eNet actionneur de commutation / à poussoir 8 voies / actionneur volet
roulant 4 voies, modulaire
Operating hours up
Operating hours down
Extended channel settings "Venetian blind"
Parameters
Operating mode
Manual commissioning
Local Operation
Running time
Slat change-over time
Fabric-stretching time
Minimum change-over-time
82581933
J0082581933
0...65535
Basic setting: Current value
0...65535
Basic setting: Current value
Setting options, Basic set­
ting
Roller shutter
Venetian blind
Awning
Basic setting: Roller shutter
On, Off
Basic setting: On
On, Off
Basic setting: On
1 ... 600 sec
Basic setting: 120 s
0 ms ... 10 sec
300 ms ... 10 s
Basic setting: 0 ms / 300 ms
300 ms ... 10 sec
Basic setting: 1 s
16/20
The time is counted during
which the load is physically
switched on (relay contact clo-
sed).
This parameter can be reset to
"0", for example after exchan-
ging the load.
The Reset button is used to
reset the meter to "0". The de-
vice must be programmed to
apply the change.
The time is counted during
which the load is physically
switched on (relay contact clo-
sed).
This parameter can be reset to
"0", for example after exchan-
ging the load.
The Reset button is used to
reset the meter to "0". The de-
vice must be programmed to
apply the change.
Explanations
See Device and channels.
Blocks manual commissioning
for the device channel. In the
"Off" setting, the device can-
not be reset to the factory set-
ting.
Blocks the output for operation
using the button.
Absolute time which the
blind/shutter requires from the
top to the bottom end position.
The entry is essential if scene
or position movements are to
occur.
Absolute time for changing-
over Venetian blind slats. The
fabric stretching time can also
be set here for the Awning
operating mode.
Minimum interruption time
when changing directions. In-
creasing the minimum
change-over time will cause
less wear on the motors.
23.03.2017