Jung 500.600.110 Instructions D'utilisation page 15

eNet actionneur de commutation / à poussoir 8 voies / actionneur volet
roulant 4 voies, modulaire
Deactivate sun protection swit-
ching state
Priority, twilight
Activate twilight switching
state
Deactivate twilight switching
state
Switch off brightness over-
shoot
Switch on brightness under-
shoot
Invert switching output
Minimum switching repeat
time
Channel settings "Venetian blind"
Parameters
82581933
J0082581933
On, Off
Basic setting: Off
0...4
Basic setting: 0
On, Off
Basic setting: On
On, Off
Basic setting: Off
On, Off
Basic setting: On
On, Off
Basic setting: Off
On, Off
Basic setting: Off
100 ms ... 10 sec
Basic setting: 100 ms
Setting options, Basic set­
ting
15/20
Defines the behaviour of the
output on deactivating the sun
protection. Only visible when
the priority for the sun protec-
tion is 0.
Specifies the priority for recal-
ling and removing a scene of
type Twilight for the channel.
Defines the behaviour of the
output on activating the twi-
light function.
Defines the behaviour of the
output on deactivating the twi-
light function. Only visible
when the priority for the twi-
light function is 0.
Allows automatic switch-off
according to the brightness. If
the parameter is On, then the
light controller switches off au-
tomatically when the bright-
ness setpoint is greatly excee-
ded. This parameter is not yet
active, as a light controller has
not yet been implemented.
Allows automatic switch-on
according to the brightness. If
the parameter is On, then the
light controller switches on au-
tomatically when the bright-
ness setpoint is greatly under-
shot. We recommend only
using the parameter in
connection with the parameter
"Switch-off on brightness over-
shoot". This parameter is not
yet active, as a light controller
has not yet been implemen-
ted.
Inverts the switching output
from NO contact function (fac-
tory setting) to NC contact
function
Limits the switching speed of
the device by increasing the
value, in order to protect the
load, for example. Only when
the set time has elapsed is
switching possible again. The
last command during the blo-
cking time is executed after a
delay. The switching repeat
time starts after each swit-
ching operation.
Explanations
23.03.2017