Vivanco AV Control 3 Mode D'emploi page 2

(GB) Instructions
Using the Vivanco AV Control 3 allows up to 3 audio-
video devices to be connected comfortably to one TV
scart socket. In addition, recordings can be made simply
using a recorder.
Connecting
1. Insert the plug of the Control 3 TV cable into a free
socket on your TV.
2. If the sound is to be reproduced via a separate hi-fi
system, connect the Audio out sockets to a free input
on the system using a standard pair of phono cables.
3. Connect AV (Audio Video) devices (SAT, DVD, etc.) to
the AV1, AV2 and AV3 sockets using fully wired scart
cables. Always connect any other recording device
(video recorder, etc.) to the AV1 (VCR) socket. VHS or
S-Video devices can also be connected using partially
wired cables and/or adapters.
Switching over to the TV
1. Select the required program source by pressing
button AV1, AV2 or AV3.
– If there is no sound and/or pic-
ture, switch the connected TV to AV using the TV's remote con-
trol. Refer to the TV's instruction manual
2. RGB: For RGB program sources set the RGB button
to on to receive the best possible picture quality. To
play non-RGB devices (video recorder, camcorder,
etc.) set the RGB button to off to prevent picture inter-
ference.
Copying
1. Set the RGB button to off.
.
2