After Use - fun pro THREE Mode D'emploi

EN
16

AFTER USE

Insert handlebar ends
You can now turn the handlebars
freely. It is best to stand in front of
the scooter and align the front wheel
as desired. Stand so that the front
wheel is held by your feet. Then align
the handlebars.
As shown above, this is the correct
alignment for the front wheel.
Tighten the screws of the clamp
again. This fixes the handlebars in
the selected wheel position.
The bar ends are secured with a
catch rope in the T-piece of the
handlebar and can thus not be
lost. For transport and also when
removing from the box, the bar ends
are clipped into the holders on the
handlebar. Remove the bar ends by
gently pulling them out of this.