Dr.Junghans Rollator Premium Manuel D'utilisation page 15

When the lever is fully
releasing, the plastic part and
the round cover will be
detached, details as figure.
Assembly and disassembly of the quick release kit:
 Assembly: Insert the wheel axle into the hole inside the wheel support until a "click" is
heard, then the wheel is fixed into the correct position. The wheel kit will not be pulled out
even with opposite force (figure 7.1).
 Disassembly: Press the red button by one hand, and take the wheel kit out of the wheel
support.(figure 7.2)
Figure7.1
INSTALL/ ADJUST THE HANDLE TUBE/ BRAKE
NOTE: Please refer to the FOLDING/ ASSEMBLY WARNINGS in the SAFETY SUMMY of
this instruction.
Adjust the rollator height so that when the user's arm is down to their side, the handgrip is
at wrist height. This will ensure the arms are at an approximate 20°-30° bend when using
the rollator.
1. Depress the snap button on the handrest tube of the Rollator and slide the handrest
tube up and down to the desired height. Ensure the sanp button protrudes through the
appropriate adjustment hole on the handrest tube. (figure 8)
Unlock the left and right lever from the slot. Put out
the lever and roatate it by 90 degree.
Figure 6 Entirely folding
5
Wheel support
Figure7.2