Zanussi ZFU20223WA Notice D'utilisation page 7

CARE AND CLEANING
WARNING! Refer to Safety chapters.
CLEANING THE INTERIOR
Before using the appliance for the first time, the
interior and all internal accessories should be
washed with lukewarm water and some neutral
soap to remove the typical smell of a brand-new
product, then dried thoroughly.
CAUTION! Do not use detergents,
abrasive powders, chlorine or oil-
based cleaners as they will damage
the finish.
PERIODIC CLEANING
CAUTION! Do not pull, move or
damage any pipes and/or cables
inside the appliance.
CAUTION! Do not damage the
cooling system.
The equipment has to be cleaned regularly:
1. Clean the inside and accessories with
lukewarm water and some neutral soap.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
The appliance is noisy.
Audible or visual alarm is on.
The compressor operates
continually.
2. Regularly check the door seals and wipe them
3. Rinse and dry thoroughly.
4. If accessible, clean the condenser and the
DEFROSTING OF THE FREEZER
The freezer compartment is frost free. This means
that there is no build up of frost when it is in
operation, neither on the internal walls, nor on the
foods.
PERIODS OF NON-OPERATION
When the appliance is not in use for long periods,
take the following precautions:
1. Disconnect the appliance from electricity
2. Remove all food.
3. Clean the appliance and all accessories.
4. Leave the door/doors open to prevent
Possible cause
The appliance is not suppor-
ted properly.
The cabinet has been recently
switched on or the tempera-
ture is still too high.
The temperature in the appli-
ance is too high.
Temperature is set incorrect-
ly.
clean to ensure they are clean and free from
debris.
compressor at the back of the appliance with a
brush.
This will improve the performance of the
appliance and save electricity consumption.
supply.
unpleasant smells.
Check if the appliance stands
stable.
Refer to "Door Open Alarm/Indi-
cator" or "High Temperature
Alarm/Indicator".
Refer to "Door Open Alarm/Indi-
cator" or "High Temperature
Alarm/Indicator".
Refer to "Operation"/"Control
Panel" chapter.
Solution
7