Axis Communications Q60 Serie Guide D'installation page 14

AXIS Q60 Series
How to install the camera
The Axis product can be mounted with the cables routed through or along the wall or ceiling.
Choose one of the following ways to install your camera:
• Install the camera with a hard ceiling mount on page 14.
• Install the camera with a drop ceiling mount on page 15.
• Install the camera with a bracket mount on page 18.
Install the camera with a hard ceiling mount
1. Prepare the ceiling for installation of the mounting plate. Use the mounting plate as
a template to position the holes. Make sure to use drill bits, screws and plugs that
are appropriate for the material.
2. Install the mounting plate. The arrow on the mounting plate will align with the logotype
on the camera.
1
Mounting plate
2
Safety wire
3. Loosen the camera base lid screws and remove the camera base lid.
4. Secure the camera using the supplied safety wire.
5. Route and connect the network cable and, if used, the multi-connector cable to the
camera.
NO TICE TICE
NO NO TICE
• Be careful not to damage the cables when connecting them.
• Make sure that the foam gasket holes are aligned with the cable tracks. If using a
multi-connector cable, remove the cut-out piece for the multi-connector cable from
the foam gasket.
14