Rack Mounting - AUDIOropa ProLoop D15 Mode D'emploi

4.5 Rack mounting
4.5.1 Ventilation and rack mounting
Leave a space of 1U (44mm) above the loop driver.
Leave a space of at least 168 mm behind the loop driver.
168 mm
44 mm
Attention, Warning, Danger :
The loop driver contains an advanced protection circuit, which allows it to reduce the
power output to maintain safe operating temperatures. Insufficient ventilation may cause
the amplifier output power to be reduced during normal operation (indicated by the red
PROTECT LEDs lighting up).
To reduce the risk of thermal limitation and to allow proper heat dissipation, it is recom-
mended to keep the space directly above and behind the device clear.
4.5.2 Rack integration
Fit the included rack mounting brackets as shown in the following image, using the provi-
ded mounting screws.
Then install the loop driver into the rack.
26 English