Installation - Booster With Backrest - Harmony DREAMTIME ELITE Manuel D'instructions

INSTALLATION - BOOSTER WITH BACKREST

DUE TO VARYING ANGLES OF VEHICLE SEAT BELT
RETRACTORS, EXCESS SLACK IN THE VEHICLE BELT
SYSTEM MIGHT NOT BE REMOVED AUTOMATICALLY.
Once the lap and shoulder portions of the seat belt
are properly positioned and the buckle is attached,
FEED ANY REMAINING SLACK OF THE SEAT BELT
MANUALLY BACK INTO THE RETRACTOR TO TIGHTEN
THE WHOLE SYSTEM.
1. Place the booster seat flush against a forward-facing
vehicle seat. The vehicle seat MUST be equipped with
a 3-point lap-and-shoulder belt. Booster must be
level, stable and not rock side-to-side (see "Vehicle
seating positions").
2. Place child in the booster seat with
child's back flat against the back of
the booster seat.
3. Adjust headrest height so that
the bottom of the headrest is
EVEN with the top of the child's
shoulders
"Headrest height adjustment".
4. Thread
belt portion
the 3-point lap-
and-shoulder belt
system
the shoulder belt
guide
ensure that shoulder belt lies across child's shoulder
and chest, and NOT across child's face or neck.
5. Thread both sides of the lap belt under BOTH
armrests. Thread the lower end of the shoulder
21
WARNING!
!
❶.
shoulder
of
through
❷ and
See section
❷
❸
❶