Dimplex Revillusion RLG20 EU Mode D'emploi page 7

Installation
Assembly
1
. Place the log set into position.
a. Lift the log set by holding the
sides of the heater box for
stability. Do not lift by gripping
the logs or the front grate legs.
b. If installing the unit on a carpeted
area, place a one-piece, solid,
flat surface under the unit. Make
sure that both of the grate feet
rest securely on this surface.
CAUTION: Each of the Realogs™
contain LEDs that pulse and glow. Handle
the log set carefully. They are fragile and
can crack or break if dropped.
2.
Install the Mirage Flame Panel by
inserting the bottom edge into the
tabs between the back log and grate
log assemblies.
a. The painted side should be to
the back and the smooth side to
the front.
b. Position the screen so that the
cutout in the middle of the flame
panel aligns with the center tab
on the grate. Start on one end of
the grate and insert the screen
into all the tabs across the
grate. When in place, the screen
should be centered and slightly
curved.
3.
Plug the unit into a mains power
socket of the correct rating.
!
NOTE: A dedicated, properly fused
13 Amp circuit is required, rated for
the appropriate voltage (230-240V).
GB
7