Loading Paper - Canon Pixma TS700 Serie Démarrage

Setting Up the Printer
4. Installing the Ink Tanks
1
Open the top cover.
Caution
Do not touch the print head holder until it stops moving.
2
Remove the tape and film on the ink tanks.
b
•
Check that no tape is left over.
3
Slowly remove the orange cap.
Important
•
Do not squeeze the ink tank with the
Y-shaped air hole blocked.
•
Do not touch the areas shown in red.
4
Install the ink tanks.
•
Matching the color of the ink tank to the label on the
print head, insert the ink tank into the print head, and
press down until it clicks.
2
a
5
Check that the mark appears on the screen.
Important
If the mark is not displayed on the screen even though
you have installed the ink tank, the color of the ink tank may
be wrong or you may have installed an ink tank, such as one
with a different model number, that is not supported by this
printer. Either install an ink tank for the correct color or use the
provided ink tank for setup.
6
Repeat steps 2 through 5 to install all the ink
tanks.
•
Check that a mark is displayed on the screen for
each color.
7
Close the top cover.
•
The printer will start initializing.
8
When the following screen appears, press the
OK button.

5. Loading Paper

1
When the following screen appears, use the [
and ] buttons to select Yes, and then press the
OK button.
•
The following screen appears.