Herth+Buss AirGuard Notice D'emploi page 61

All manuals and user guides at all-guides.com
Operating Instruction
Programming an unused sensor:
The AirGuard will now program the sensor
for you by deleting the flash memory, pro-
gramming the sensor and checking.
Programming complete:
If the programming process has completed
successfully,youwillheartwoshortbeeps.
Please note:
Press the enter key again to reprogram
the sensor. You can overwrite the
Herth+Buss wheel sensor several times.
61
4.5. Generating a full sensor set Wireless
(re)programming
For wireless (re)programming it must be en-
sured that
All 4/5 sensors are activated
These are written with different IDs
The AirGuard does this for you automati-
cally. It is irrelevant whether Wheel: 1 or
Wheel: 4 has been set in the Settings menu.
Ifyouwanttoprogrammacompletesetof
tyres,werecommendtochangeonwheel:4,
foryourownoverfiew.
Function selection
Wireless (re)programming is implemented
as follows with the new sensors 70699443
and 70699434:
Selectyourvehicleintheusualway.
Select the function New sensor > Gene-
rate sensor
Select Wireless Program
95990001
EN