End Of Programme; Maintenance And Cleaning; Cleaning The Detergent Drawer - Beko WMB 71041 Manuel D'utilisation

If you want to open the loading door after you
C
have cancelled the programme but it is not
possible to open the loading door since the
water level in the machine is above the loading
door opening, then turn the Programme
Selection knob to Pump+Spin programme and
discharge the water in the machine.
Machine is in Rinse Hold mode
Spin symbol flashes and Pause symbol illuminates
when the machine is in Rinse Hold mode.
If you want to spin your laundry when the machine is
in this mode:
Adjust the spin speed and press Start / Pause /
Cancel button. Pause symbol disappears and Start
symbol appears. Programme resumes, discharges
the water and spins the laundry.
If you only want to drain the water without spinning:
Just press Start / Pause / Cancel button. Pause
symbol disappears. Start symbol appears.
Programme resumes and discharges the water only.

End of programme

"End" appears on the display at the end of the
programme. Symbols of the programme steps
remain lit. Auxiliary function, spin speed and
temperature that were selected at the beginning of
the programme remain selected.
Your machine is equipped
with a "Standby Mode"
In case of not starting any programme or waiting
without making any other operation when the
machine is turned on by On/Off button and while it is
in selection step or if no other operation is performed
approximately 2 minutes after the programme
you selected has come to an end, your machine
will automatically switch to energy saving mode.
Brightness of indicator lights will decrease. Also,
if your product is equipped with a display showing
the programme duration, this display will completely
turn off. In case of rotating the Programme Selection
knob or pressing any button, lights and display will
restore to their previous condition. Your selections
made while exiting the energy saving mode may
change. Check the appropriateness of your
selections before starting the programme. Readjust
if necessary. This is not a fault.

5 Maintenance and cleaning

Service life of the product extends and frequently
faced problems decrease if cleaned at regular
intervals.

Cleaning the detergent drawer

Clean the detergent drawer at regular intervals (every
4-5 washing cycles) as shown below in order to
prevent accumulation of powder detergent in time.
Press the dotted point on the siphon in the softener
compartment and pull towards you until the
compartment is removed from the machine.
If more than normal amount of water and
C
softener mixture starts to gather in the softener
compartment, the siphon must be cleaned.
Wash the detergent drawer and the siphon with
plenty of lukewarm water in a washbasin. Wear
protective gloves or use an appropriate brush to
avoid touching of the residues in the drawer with
your skin when cleaning. Insert the drawer back
into its place after cleaning and make sure that it is
seated well.
If your detergent drawer is the one indicated in the
following figure:
Lift the rear part of the siphon to remove
C
it as illustrated. After performing the above
mentioned cleaning procedures, replace the
siphon back to its seating and push its front
section downwards to make sure that the
locking tab engages.
Cleaning the water intake filters
There is a filter at the end of each water intake valve
at the rear of the machine and also at the end of
each water intake hose where they are connected to
the tap. These filters prevent foreign substances and
dirt in the water to enter the washing machine. Filters
should be cleaned as they do get dirty.
15
EN