EDM Product 08767 Manuel D'instructions page 51

· The charger will communicate with the battery pack to evaluate
the condition of the battery pack.
· The red lights on while the battery pack is charging. After charging
is complete, the green LED on the charger will be on.
· After approximately1h, battery is fully charged.
· Unplug the charger, and then remove the battery pack.
WARNING
Never use a damaged battery pack.
Always disconnect the charger from the power source
when it is not in use.
NOTE: The battery pack and charger will become slightly
warm to the touch while charging. This is normal and
does not indicate a problem.
NOTE: If you wish to charge two battery packs in succes-
sion, unplug the charger and allow at least 15 minutes
between charges.
WARNING
- The charger supplied is matched to the Li-ion battery
installed in the machine. Do not use another charger.
- This cordless drill is integrated over-charge protection,
when the battery cell was over-charge, the over-charge
protection will operate to stop charge battery.
- During the charging procedure, the battery warms up,
this is normal.
Instruction manual Ref. 08767
ES
PT
EN
FR