EDM Product 08767 Manuel D'instructions page 50

OPERATION
ES
Before use
· Remove any packing material and loose parts from unit.
· Check the accessories before use. It should be fit with the machine
PT
and your purpose.
· If the machine is new, the battery must first be charged.
Attention! After long time storage, the battery capacity will be
reduce.
EN
A new battery or one which has not been used for an extended
period achieves full performance only after charging and dischar-
ging cycles. A substantial drop in operating period per charge indi-
FR
cates that the battery is worn out and must be replaced.
Battery charger (Fig. 1)
The lithium-ion battery can be charged at any time and will not
develop a "memory" when charged after only a partial discharge. It
is not necessary to run down the battery pack charge before rechar-
ging. Remove the battery pack from the tool when convenient for
you and your job. You can "top-off" your battery pack's charge before
starting a big job or long period of use.
Due to lithium-ion's fade-free properties, the only time it is neces-
sary to charge the lithium-ion battery pack is when the pack has
reached the end of its charge. To signal the end of charge, power to
the tool will drop quickly. Charge the battery pack as needed.
Charging the battery
This lithium-ion battery pack is shipped partially charged. Before
using it the first time, fully charge the battery pack. A fully dischar-
ged battery pack with a temperature between 0
charge in about 1 hour.
· Charge the lithium-ion battery pack only with the correct charger.
· Connect the charger to a power supply.
· Insert the battery pack into the charger, making sure the battery
pack is fully seated.
Instruction manual
Fig.1
Ref. 08767
and 40 will