Publicité
Les langues disponibles
Les langues disponibles
Burner cap
Adapter
Cup
Spanner
Injector
Adjusting the reduced flame position
First of all, make sure that the appliance
is unplugged from the mains electrical
supply and that the gas feed is open. The
minimum flame position is adjusted with a
flat screw located on the valve. For valves
with a flame failure safety device, the screw
is located on the side of the valve spindle
as shown in the figures. For valves without
a flame failure safety device, the screw is
located inside the valve spindle as shown
in the figure below. To make adjusting the
flame position easier, we recommend that
you remove the control panel (and the
micro switch if your model has one) during
the alteration.
To determine the minimum position, ignite
the burners and leave them on in the
minimum position. With the help of a small
screwdriver, fasten or loosen the bypass
screw by around 90 degrees. When the
flame has a length of at least 4mm, the gas
is well distributed. Make sure that the flame
does not die out when passing from the
maximum position to the minimum position.
Create an artificial wind with your hand
towards the flame to see if the flames are
stable.
The bypass screw must be loosened for
conversion from LPG to NG. For conversion
from NG to LPG, the bypass screw must be
tightened. Make sure that the appliance is
unplugged from the mains electrical supply
and that the gas feed is open.
Valve with flame failure device
Bypass screw
Valve with flame failure
device
Bypass
screw
Changing the gas inlet
For some countries, the gas inlet type
can be different for NG/LPG gases. In
this case, remove the current connection
components and nuts (if any) and connect
the new gas supply accordingly. In all
conditions, all components used in gas
connections should be approved by local
and/or international authorities. In all gas
connections, refer to the "Assembly of
gas supply and leakage check" clause
explained above.
2.5
WARNING: The electrical connection
of this appliance should be carried out
by an authorised service person or
qualified electrician, according to the
instructions in this guide and in compliance
with the current local regulations.
WARNING: THE APPLIANCE MUST
BE EARTHED.
•
Before connecting the appliance to the
power supply, the voltage rating of the
appliance (stamped on the appliance
identification plate) must be checked for
correspondence to the available mains
supply voltage, and the mains electric
wiring should be capable of handling the
appliance's power rating (also indicated
on the identification plate).
•
During installation, please ensure
that isolated cables are used. An
incorrect connection could damage
your appliance. If the mains cable is
damaged and needs to be replaced this
EN - 14
Valve without flame
failure device
Bypass
screw (Inside
the hole)
Publicité
