Télécharger Imprimer la page

Oceanic OCEATG2VB Notice D'utilisation page 36

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
All metal items that are used during
gas connection must be free from
rust. Check the expiry date of any
components used for connection.
Points that must be checked during
fixed gas connection assembly
The method used to assemble a fixed
gas connection (gas connection made by
threads, e.g. a nut) varies according to the
country you are in. The most common parts
for your country will be supplied with your
appliance. Any other parts required can be
supplied as spare parts.
During connection, always keep the nut
on the gas manifold fixed while rotating
the counter-part. Use appropriately-sized
spanners for a safe connection. For
surfaces between different components
always use the seals provided in the gas
conversion kit.
The seals used during connection should
also be approved to be used in gas
connections. Do not use plumbing seals for
gas connections.
Remember that this appliance is ready
to be connected to the gas supply in the
country for which it has been produced.
The main country of destination is marked
on the rear cover of the appliance. If you
need to use it in another country, any
of the connections in the figure below
may be required. In this case, contact
local authorities to learn the correct gas
connection.
Gas pipe
Seal
Hose
fitting
Hose
fitting
Gas hose
with collar
Gas pipe
Gas pipe
Seal
Seal
Hose
Hose
fitting
fitting
Gas hose
gas hose
with collar
Gas pipe
Seal
Hose
fitting
Hose
fitting
gas hose
The Cooker must be installed and
maintained by a suitably qualified gas
registered technician in accordance with
current safety legislation.
WARNING: Do not use a naked flame
to check for gas leaks.
2.4
Your appliance is designed to be operated
with LPG/NG gas. The gas burners can
be adapted to different types of gas, by
replacing the corresponding injectors and
adjusting the minimum flame length suitable
to the gas in use. For this purpose, the
following steps should be performed.
Changing injectors
Hob burners
Cut off the main gas supply and unplug
the appliance from the mains electrical
supply.
Remove the burner caps and the
adapters.
Use a 7 mm spanner to unscrew the
injectors.
Replace the injector with the ones from
the gas conversion kit, with the correct
diameters for the type of gas that is
going to be used, according to the gas
injector table.
cal
EN - 13
Gas pipe
Hose
fitting
cal
gas hose
cal

Publicité

loading