Preparation - Pari MONTESOL Notice D'utilisation

2

Preparation

Image 1
Familiarise yourself with the nasal douche before using it for the first time.
The PARI MONTESOL nasal douche consists of 4 parts:
(1) Nasal insert
(2) Bend
(3) Reservoir
(4) Valve
How do I will the PARI MONTESOL nasal douche?
Image 2
• Place the nasal insert (1) on the bend (2) (already pre-fitted at shipment).
Ensure that the small pin (a) on the bend has engaged in the slot (b) in the
nasal insert.
• Turn the nasal insert to the STOP position (flow will be blocked):
The STOP label on the nasal insert must be aligned with the marking on the
bend (line).
Image 3
• Set the nasal douche down with the valve (4) at the bottom.
• Unscrew the bend (2) from the nasal douche.
Image 4
• Fill the nasal douche with the correct dose of brine or saline solution in ac-
cordance with the instructions for use.
• Fill the nasal douche up to the lower edge of the screw thread (see arrow)
with drinking water at body temperature.
Image 5
• Then screw the bend (2) firmly back onto the reservoir (3). Ensure that the na-
sal insert (1) is in the STOP position (see Image 2).
• Turn the nasal douche over.
• Rock the nasal douche gently back and forth to mix the brine or saline solu-
tion thoroughly with the drinking water.
EN
11