Elica SNAP Mode D'emploi page 22

4.
DISCONNECT THE CONNECTION CABLE INSIDE THE AESTHETIC
COVER
EN
6.
PREPARE WHAT IS NEEDED FOR FIXING THE APPLIANCE
6a.
position the rear body on the out-let hole
10
5.
CHOOSE WHICH SIDE YOU WANT THE CABLE TO GO
THROUGH, AND THEREFORE CUT OUT THE REAR BODY IN THE
CORRESPONDING POINT
6b. use the rear body as a template to 6c. drill the 4 holes in the wall,
mark the fixing holes according to the marks, and
insert the anchors
7.
REMOVE THE CLOSURE PIECE OF THE FRAME
9. POSITION THE ELECTRIC CABLE ACCORDING TO THE FOLLOWING SOLUTIONS
9a. outlet with cable on the left
or on the top part
8.
POSITION THE FRAME BASED ON THE DIRECTION CHOSEN FOR
THE CABLE TO GO THROUGH
8a. outlet with cable on 8b. outlet with cable
the top part to the right
8c. outlet with cable 8d. outlet with cable
to the left on the bottom part
9b.
Outlet with cable
to the right 9c.
Outlet with cable
on the bottom
EN
11