Elica SNAP Mode D'emploi page 20

3_How to prepare for installing Snap
SNAP COMPONENTS
EN
A B
glass aesthetic
cover
WHAT IS NEEDED FOR INSTALLATION
Ø 120 mm
+
a 120 mm diameter hole mains power
in the wall network
CHOOSE THE BEST SOLUTION
Snap can be installed with either a hidden power cord or visible cable.
Choose the best solution for your needs.
HIDDEN POWER CORD INSTALLATION PROCEDURE (4A)
VISIBLE CABLE INSTALLATION PROCEDURE (4B)
4
+ o
C D E
rear frame cable clamp
body frame closing element
(x4)
+ + +
drill Screws Screwdriver
and anchors
4A_Hidden power cord installation procedure
Before starting the procedure, make sure that you have switched off the home main power switch.
1.
MAKE A HOLE IN THE WALL OR USE AN ALREADY EXISTING ONE
3.
DISENGAGE THE AESTHETIC COVER BY GENTLY PRESSING ON THE REAR PANEL
3a
+
Box cutter
2.
REMOVE THE GLASS FROM THE AESTHETIC COVER, BY GENTLY
PRESSING ALL ALONG THE PERIMETER IN ORDER TO DISENGAGE
IT FROM THE MAGNETS
Ø 120 mm
20 mm
3b
EN
5