Télécharger Imprimer la page

System Requirements - Roccat Kone Pro Air Instructions

Publicité

D R I V E R L E S S S E T U P
Press the profile button in combination with the left mouse button for
three seconds to enter config mode. The mouse will blink in the color
of the active profile. To exit config mode, press the profile button in
combination with the left mouse button for three seconds once more.
Scroll up/scroll down: Change DPI level from available
presets. LEDs will fade into one of the colors listed
below to reflect the chosen DPI preset.
400 DPI – red
800 DPI – green
200 DPI – cyan
600 – blue
3200 – pink
Forward side button/backward side button: Change
polling rate. The right mouse button will blink in one of
the colors listed below to reflect the chosen polling rate.
2 Hz – blue
2 0Hz – green
00Hz – yellow
000Hz – white (default)
Wheel click: Swap between mm and 2mm lift-off dis-
tance. The left mouse button will blink in one of the co-
lors listed below to reflect the chosen lift-off distance.
mm – red
2mm – green
While holding the left mouse button, press forward side
button/backward side button: Change LED brightness
in steps of 0%.
While holding the right mouse button, press forward
side button/backward side button: Change between
Static, Wave, Heartbeat, Breathing or Blinking RGB
modes. The effect is immediately shown on the mouse.
While holding the left or right mouse buttons and wheel
up/down: Change the color of the LEDs corresponding
to the button held from 6 presets. When both are held
at the same time it changes both at once. Changes are
immediately shown on the mouse.
T E C H N I CA L FA CT S
TECH SPECS KONE PRO AIR
ROCCAT
Owl-Eye 9K dpi optical sensor
®
(based on PixArt PAW3370)
400 IPS ( 0.2m/s) maximum speed
0g maximum acceleration
(stop to maximum speed in 0.03s required to reach limit)
Default DPI steps: 400, 800 (default), 200, 600, 3200
2.4GHz frequency
Bluetooth
mode
®
4 0 mAh battery, 00h+ battery life without RGB
ROCCAT Phantom Flex™ USB-C charging cable
000Hz polling rate
Lift-off distance: mm, 2mm and surface calibration
ARM32 M0+ MCU
ROCCAT Titan Switch Optical, 00 million click life-cycle
7 g weight
Should you need assistance ...
Our support team is ready to help you with any technical questions.
Just send an e-mail to support@roccat.com or visit our website at:
W W W.ROCCAT.COM/SUPPORT

SYSTEM REQUIREMENTS

Windows
7, 8 and 0 (software support)
®
USB 2.0 (or higher)
Internet connection

Publicité

loading

Produits Connexes pour Roccat Kone Pro Air