Uline DOWNTOWN 52 po Mode D'emploi page 2

NOTE: Place all laminate panels on a clean,
smooth surface to prevent scratches.
NOTE: Count and inspect all pieces before
disposing of any carton or packing materials.
If assembling a mobile divider, follow starter
divider assembly below. Casters will be
attached at the start of assembly.
If using add-on dividers, the starter divider
must be assembled first. The add-on dividers
can then be assembled and connected to the
starter divider. See page 4 for add-on assembly.
1a. For stationary divider, insert four bolts (A) through
underside of steel foot and attach to post. Tighten
using Allen wrench. Repeat for other steel foot and
post. (See Figure 1a)
Figure 1a
Post
Steel Foot
A
1b. For mobile divider, attach two locking casters (D)
to underside of mobile steel foot using caster cap
(E) and hex nut (F). Tighten using open end wrench.
Insert four bolts (A) through underside of mobile steel
foot and attach to post. Tighten using allen wrench.
Repeat for other mobile steel foot and post.
(See Figure 1b)
Figure 1b
F
F
D
Mobile
Steel Foot
D
E
E
PAGE 2 OF 15
STARTER DIVIDER ASSEMBLY
Post
A
NOTE: Assembly for stationary and mobile
dividers is the same for remaining steps.
Casters are not shown in any of the remaining
figures.
2. Using two people, stand posts upright. Place
horizontal bar between posts. Insert lock on end of
horizontal bar into channel on post. Tighten locks
using Allen wrench. Repeat for other end.
(See Figure 2)
NOTE: Steel feet should be facing inward for
improved stability.
NOTE: Locks are built into the ends of the
horizontal and vertical bars. Locks will require
approximately a 1/2 turn in order to engage
the lock and connect bars and posts.
Figure 2
Horizontal
Bar
Post with
Steel Foot
Lock
1122 IH-9157