RayLight STROBES Fiche Technique page 5

During the transportation/storage/set up, be careful not to impact/chock/drop the
generator.
During the mounting, please strictly follow the instruction guide provided with
the device and the wiring recommendations and tools.
Raylight Technologies does not guarantee its products outside these limitations.
The mounting of the device must be done under these conditions:
Strictly respect the assembly instructions.
The assembly order must comply to the instructions.
The wires must go through foam inserts to ensure sealing.
The polarity « Led + / Led- » must be respected : short-circuits risks, creation
of a hot spot leading to the destruction of the LED board.
The tightening of the polycarbonate protective layer ULV0 torque must be
done by hand: tighten with a manual screwdriver without forcing, do not use
anelectrical screwdriver (see assembly instructions). Tightening must be
enough to crush the sealing foam to ensure the sealing of the LED board.
Place the light device at more than one meter from flammable or explosive
(example: fuel tank).
In case of a purchase of the device without the lens, Raylight Technologies
dischargeof all responsibility.
Raylight Technologies does not guarantee its products outside these limitations.
Declare a non-compliance
Raylight Technologies reserves the right to accept the non-compliance upon receipt
of the defective product.
Shipping charges of a potentially defective product are the responsibility of the
customer.
If the non-compliance is proven, Raylight Technologies will issue a refund of the
shipping charges.
RAYLIGHT TECHNOLOGIES
Aérodrome du Versoud
38420 LE VERSOUD
Internal
FTECH-2022-000002-V7
Last Update: 11/10/2022
Page 5/31