Assembly - RayLight STROBES Fiche Technique

2.2.

Assembly

- Insert two wires into the holes (1) of Insert two wires into the holes (1) of
the foam and the LED board.
- Connect(2) + LED and – LED to one of
the generator output (see image the generator output (see image
thereafter).
- Place the screws : M3 screw, washer, Place the screws : M3 screw, washer,
PTFE shoulder washer, strobes PTFE shoulder washer, strobes
assembly, wing tips of your plane, assembly, wing tips of your plane,
washer and nut. Gently tighten by washer and nut. Gently tighten by
hand.
RAYLIGHT TECHNOLOGIES RAYLIGHT TECHNOLOGIES
Aérodrome du Versoud
38420 LE VERSOUD
LED to one of
Internal
FTECH-2022-000002-V7 FTECH
Last Update: 11/10/2022 Last Update: 11/10/2022
Page 12/31