Publicité
Les langues disponibles
Les langues disponibles
3. Remove heat shields - Using a 10mm socket remove the nuts holding the heat shield, using a 7mm socket remove the screw holding the heat shield to the
wheel well liner, remove the heat shield. Cut a 1.5" hole forward of the forward attachment in the heat shield to clear the middle fastener for the hitch, see Fig. 2.
Set fasteners aside for reinstallation.
5"
©2019 Horizon Global™ Corp - Printed in Mexico
Sheet 6 of 33
36787NP
8-8-19
Rev. A
Publicité
