Beyerdynamic Aventho Wired Manuel page 5

Aventho wired – Headphones 5
Storage and removal from the packaging
Removal from the packaging
Hold the Aventho wired on the headband
and pull it out of the textile bag. Rotate
the two ear cups inward so that the ear
pads are facing each other. Refer to the
illustration.
Storage
Disconnect the cable from the ear cups.
Rotate the two ear cups as indicated by
the arrows. Hold the Aventho wired and
put it into the textile bag with the ear cups
first. Refer to the illustration.
How to adjust the headband
Before wearing the Aventho wired for the first time you should adjust it properly to
achieve the best sound and ambient noise attenuation.
Please refer to the following tips:
• Select the appropriate lock-in position on both sides of the headband.
• Adjust the angle of the ear pads.
• Place the Aventho wired centrally on your ears as shown in the middle picture.
Headphone is too high Perfect fit of the headphone Headphone is too low