Dc Voltage Measurement - Kopp GMT-19A Mode D'emploi

DC Voltage Measurement

DC Voltage Scale
DC Voltage Range
Black
1) Fully seat the test leads in the correct input jacks, (-) black
lead, (+) red lead.
2) Set the function/range switch to the appropriate DC voltage
range. If the voltage is unknown, use the highest range. If
the voltage applied falls within the range of a lower setting,
reset the function/range switch to the appropriate setting
for greatest accuracy of reading.
3) If the polarity of the circuit to be tested is known, touch
the black test lead to the neutral side. If the polarity is
unknown, touch the test leads to opposite sides of the
circuit. If the needle indicator defl ects to the left of the
scale, reverse the test leads.
Use the chart below as a guide to reading DC voltage measu-
rements:
DCV Range Setting
2.5
10
50
250
1000
Read Following
Scale
0-250
0-10
0-50
0-250
0-10
13
Red
and Multiply
Reading By:
0,01
1
1
1
100