Removing The Ground Coffee - Faema MD3000 On Demand Manuel D'installation Et Usage

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28

8. Removing the ground coffee

The measure grinder can be set with 2 different drawing
modes:
m "manual"
operation
1) Place the coffee machine's filter-holder on to the fork
(12).
2)
Select the pre-chosen measure (single
pressing the icon on the Touch Screen
3)
When the icon on the Touch Screen display is released the
measure grinder operates for the set measure-time and the
ground coffee descends from the chute (7).
Grinding is stopped automatically.
Note: the grinding cycle can be stopped before the set grinding
time by pressing the Touch Screen.
For continuous grinding press the
pressed:
-
with measure value
00.00:
long as the
icon is kept
-
with measure value other than
continuously as long as the
not over the set
time.
Note: the measure value is set by the technician.
As to measure-time settings see the DOSING paragraph.
P "Pre-selection" operation
1) Select beforehand on the Touch Screen display the measure
(single, double or continuous) that is desired to be drawn;
The active selection is represented by the black square
(displayed alternating) behind the cup icon, as shown
in the figure opposite.
2) Place the coffee machine's filter-holder on to the fork (12)
ensuring that it presses the actuator (9).
note: it is the actuator (9) pressure that operates the
grinders.
3)
The measure grinder operates for the set measure-time and
the ground coffee descends from the chute (7).
Grinding is stopped automatically.
Note: the grinding cycle can be stopped before the set grinding
time by pressing the Touch Screen.
Note: at the end of the grinding phase, the symbol
to the icon of the dose set by the technician.
Note: in the pre-selection mode, at least 2 seconds must pass
between one grinding cycle and another, and is determined
by the release of the actuator (9).
As to measure-time settings see the DOSING paragraph.
DO nOT insert any object inside the coffee
chute (7).
Measure
The grinder is supplied with a measure on its side. The center
of the CF symbol corresponds to 25 ml and approximately
7.5 grams (can vary depending on the granule size and type
of coffee).
or double
display.
icon and keep it
grinding occurs continuously as
pressed;
00.00:
grinding occurs
icon is kept pressed, but
returns
)
25 ml
P "Pre-seLeCTiOn" OPerATiOn
P
P
P
22
5
7
9
12
Single measure
Double measure
Continuous measure

Publicité

Table des Matières
loading

Table des Matières