Electricity Supply - ADB ACP 1001 Manuel D'utilisation

Horizontal and vertical barn doors
The horizontal barn door is placed on the lower edge of the
spotlight. The barn doors are supplied with fixing screws and
caged nuts. On the outside of the spotlight, press the caged
nuts into the square holes provided for this purpose. The nuts
are fixed rapidly and will not fall out again. Insert the mounting
plate of the barn doors into the two lugs situated on the side
faces and on the lower face of the spotlight. Fold the barn doors
over the front face of the spotlight for easy access to the fixing
screws. Secure the barn doors using the screw by turning it a
quarter turn.
Wire guard
Insert the two lugs of the grid support into the mounting runners.
Fold the base of the guard to the inside of the spotlight and
tighten the fixing screws.
Placement of the lamp
In accordance with the safety regulations, ALWAYS disconnect
the power cable before working on the spotlight. If the spotlight
has just been used, leave it to cool for a while or wear gloves
offering thermal protection. For the type of lamp to use, here is
the description;
Socket type R7s.
Length: 189.1 mm.
Supply voltage: 220-240 V.
Power: 625, 1000 or 1250 W.
Remove the guard and/or the protective glass so you can access
the socket from the front. Place the lamp in its socket.
Replace the guard and the safety glass. So as not to spoil the
lamp with greasy deposits, please handle it without touching the
glass part of the lamp. If this is not possible, please clean the
lamp, after placement, using a clean, lint-free cloth moistened
with alcohol. Refer to the manufacturer's datasheet supplied with
the lamp. The lamp must be replaced if it has been damaged or
deformed by the heat.
ACP 1001 Cyclorama

Electricity supply

our spotlight has been designed to operate at a maximum
Y
voltage of 220/240 V. It must be connected to the mains by
a 3-core silicon power cable; each core must have a minimum
cross section of 1.5 mm . Consult the local regulations in force.
2
The insulation of the electricity cable must withstand the normal
maximum operating temperature indicated on the identification
plate. For your safety, make sure that the earth wire (green/yellow)
is ALWAYS connected to the mains earth. Refer to figure 3 page
11 for instructions to replace a faulty power cable.
Unscrew the two screws at the back of the spotlight and remove
the perforated protective plate to access the terminal strip for the
electricity supply. Pass the cable through the protective rubber
sleeve and expose the extremity of the 3 conductors. Then insert
the cable into the cable grip. Connect the earth wire (yellow/
green) to the earth terminal and connect the other two wires to
the terminal strip. Immobilise the cable by tightening the 2 screws
of the cable clamp and put the protective plate back on securely.
Maintenance
We advise you to clean the reflectors each time you replace
the lamp. After having disconnected the power cable, remove
the wire guard and/or the safety glass, after having allowed the
spotlight to cool. Remove the lamp carefully using protective
gloves. Watch out for hot lamps. Clean the reflector using a
soft, clean cloth moistened with alcohol. Replace the lamp and
the accessories.
P a g e 7
Issue: 002