Indesit I6VV2AW Mode D'emploi page 9

Connecting the supply cable to the mains
WARNINGS: THIS APPLIANCE MUST BE EARTHED.
! The cooker must be connected to the mains by a
switched (double pole) cooker outlet correctly fused
with a capacity appropriate to that shown on the
cooker Rating Plate. All electrical wiring from the
consumer unit to the cooker, via the switched double
pole cooker outlet, must be of an acceptable type and
current rating as above.
! the supply cable must be positioned so that it never
reaches at any point a temperature 50°C higher than
the room temperature. The cable must be routed away
from the rear vents.
HOT PARTS
Safety Chain
The cooker is fitted with a safety chain to be fixed by
means of a screw (not supplied with the cooker) to
the wall behind the appliance, at the same height as
the chain is attached to the appliance.
Choose the screw and the screw anchor according
to the type of material of the wall behind the applian-
ce. If the head of the screw has a diameter smaller
than 9mm, a washer should be used. Concrete wall
requires the screw of at least 8mm of diameter, and
60mm of length.
Ensure that the chain is fixed to the rear wall of the
cooker and to the wall, as shown in figure, so that
after installation it is tensioned and parallel to the
ground level.
TECHNICAL DATA
Oven dimensions
(HxWxD)
Volume
Useful
measurements
relating to the oven
compartment
Power supply
voltage and
frequency
Electric hob
Front left
Back left
Back right
Front right
Maximum absorption
of the electric hob
ENERGY LABEL
and ECODESIGN
! In order
to prevent
accidental
tipping of the
appliance, for
example by
a child clim-
bing onto the
oven door, the
supplied safety
chain MUST be
Data plate, is located inside the flap or, after the oven
installed!
compartment has been opened, on the left-hand wall
inside the oven.
32,4x43,5x41,3 cm
59 l
width 42 cm
depth 44 cm
height 8,5 cm
see data plate
1700 W
1200 W
2100 W
1200 W
6200 W
Declared energy consumption
for Forced convection Class –
heating mode: Fan assisted
ECODESIGN Directive 2009/125/EC
GB
9