Kohler K-T11837 Guide D'installation page 3

Setscrew
Sensor Cover
1. Install the Spout
IMPORTANT! Use care when installing the spout to avoid
scratching the finish.
Remove the thread protector and save the three screws. They will
be required to attach the spout shank.
Discard the thread protector.
Thread the spout into the outlet port.
Secure the flange to the wall with the screws (wrench supplied)
that were removed from the thread protector.
Press the escutcheon firmly against the wall.
Install the Sensor Cover
Turn the setscrew (already installed in the sensor)
counterclockwise until it is tight. Do not overtighten.
Position the sensor cover and secure with the setscrew. Do not
overtighten.
Kohler Co.
Faucet Outlet Port
Discard the thread
protector.
Flange
Screws
Escutcheon
3
Spout
1085971-2-A