Door Alignment; Troubleshooting - Wolf E Serie Guide D'installation

Installation
Installation
Place the oven in the opening and slide into position. To
ensure adequate depth for proper installation, the conduit
must fit into the recessed area along the rear edge of the
oven.
Locate the mounting hole in each side trim. Drill 1/16"
pilot holes and install #6 x 3/4" screws. Refer to the illustra-
tion below.
Remove and recycle packing materials including the
white protective material behind each rack guide mounting
location.
MOUNTING
HOLE
Mounting hole
6 | English

Door Alignment

To adjust the door, loosen the nuts on both sides of the
door, manually adjust the door side to side, and tighten
the nuts. Refer to the illustration below.
(2)
NUT
Door alignment

Troubleshooting

Troubleshooting
IMPORTANT NOTE: If the oven does not operate properly,
follow these troubleshooting steps:
• Verify electrical power is supplied to the oven.
• Verify proper electrical connections.
• If the oven does not operate properly, contact Wolf
Factory Certified Service. Do not attempt to repair the
oven. Wolf is not responsible for service required to
correct a faulty installation.