Product Overview; Operation; Adjusting The Temperature; Noise Inside The Unit - INVENTOR INVMS93A2 Manuel D'utilisateur

3. PRODUCT OVERVIEW

P an
Thermos tat
S teel w ire s helf
Leveler
*All images in this instruc on manual are for indica on only; please refer to your individual unit for details.

OPERATION

4. OPERATION
4.1 Adjus ng the Temperature
The temperature selector knob is located on the right hand side
wall of the refrigerator interior
wall of the refrigerator interior
Se ng O UnitO
Se ng Min Less Cool Temperature
Se ng Med
Se ng Max
During high ambient temperatures e.g. on hot summer days. It may be necessary to set
the
thermostat to the Coolest se ng(posi on"Max").This may cause the compressor running
con nuously in order to maintain a low temperature in the cabinet.
For the rst me you install your refrigerator, set the thermostat knob at "Med".
Give your refrigerator me to cool down completely before adding food. It is the best to wait
24 hours before adding food. The thermostat knob controls the temperature. When the
thermostat control knob is set to OFF, the refrigerator will not be running.

4.2 Noise Inside the Unit!

You may no ce that your unit makes some unusual noises. Most of these are perfectly normal,
but you should be aware of them!
These noises are caused by the circula on of the refrigerant liquid in the cooling system. It has
become more pronounced since the introduc on of CFC free gases. This is not a fault and will not
affect the performance of your unit. This is the compressor motor working, as it pumps the
refrigerant around the system.
drain
leg
Normal Opera on(adequate for most situa ons)
Coolest Temperature
S mall door
Tray
5