Makita ML120 Mode D'emploi page 12

The following tables indicate the operating time on a single charge.
ML120
Voltage
12 V
(Note)
If you use a power checking battery on Model ML120, the power checking battery will not indicate the remaining bat-
tery capacity properly.
ML140
Voltage
14.4 V
ML180
Voltage
18 V
Storing battery cartridge
Always charge the Nickel Metal Hydride battery cartridge
before storing it when you do not use it for more than six
months.
Head angle (Fig. 3)
The head angle can be adjusted in four stages. Adjust as
desired.
Replacing bulb (Fig. 4 & 5)
CAUTION:
The bulb is very hot immediately after operation. Wait
until the bulb cools off before attempting to replace it.
First, turn the ring counterclockwise and remove the
reflector. Then replace the bulb.
12
Battery cartridge
1220, PA12
1202, 1202A, 1222
1234
1235, 1235A, 1235F
Battery cartridge
1420, PA14
1422
1434
1435, 1435F
Battery cartridge
PA18
1822
1834
1835, 1835F
Shoulder strap (Fig. 6)
Install the strap on the tool.
MAINTENANCE
To maintain product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by a Makita
Authorized Service Center.
Operating time
Approx. 110 min.
Approx. 160 min.
Approx. 220 min.
Approx. 260 min.
Operating time
Approx. 110 min.
Approx. 160 min.
Approx. 220 min.
Approx. 260 min.
Operating time
Approx. 130 min.
Approx. 190 min.
Approx. 260 min.
Approx. 300 min.