Product Registration - Fellowes Helios 60 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TROUBLESHOOTING
Problem
No 'red' power on LED
No 'green' ready light after a long
period
Loose and unglued sheets
Loose and glued sheets
WORLDWIDE WARRANTY
Fellowes warrants all parts of the binder to be free of defects in material and workmanship for 2 years from the date of
purchase by the original consumer. If any part is found to be defective during warranty period, your sole and exclusive remedy
will be repair or replacement, at Fellowes' option and expense, of the defective part. This warranty does not apply in cases of
abuse, mishandling or unauthorised repair. Any implied warranty, including that of merchantability or fitness for particular
purpose, is hereby limited in duration to the appropriate warranty period set forth above. In no event shall Fellowes be liable
for any consequential damages attributable to this product. This warranty gives you specific legal rights. You may have other
legal rights that vary from this warranty. The duration, terms and conditions of this warranty are valid worldwide, except where
different limitations, restrictions or conditions may be required by local law. For more details or to obtain services under this
warranty, please contact Fellowes or your dealer.

PRODUCT REGISTRATION

Thank you for purchasing a Fellowes product. Please visit www.fellowes.com/register to register your product and benefit
from product news, feedback and offers. Product details can be found listed on the rating plate positioned on the rear side or
underside of the machine.
Possible cause
Machine is not switched on
Machine is in a hot or humid area
Binding cover may be too thick to bind
Timer setting may be incorrect
The cover size is too small for the
number of sheets
Extended heating cycle
Timer setting may be incorrect
Documents left on the heater plate
after the cycle is complete
Solution
Switch on machine at rear next to plug
inlet and at the wall socket
Move the machine to a cooler and dry
area
Process the documents again, ensure
sheets are in contact with the glued spine
by tapping gently on a flat surface
Check timer setting is correct and process
the document again
Check the number of sheets is appropri-
ate for the cover width. Select larger
spine width if necessary
Check timer setting is correct. Ensure
prompt document removal
7

Publicité

Table des Matières
loading

Table des Matières